AB++ MOSFET - Perun

AB ++ MOSFET Kit
Perun brand
Manual: Click HERE

AB ++ is an on-wire MOSFET, which routes power from the battery to the motor through a specialized high-power transistor, instead of delicate mechanical switches, increasing reliability and replication performance. Also improve your replication by adding many new and useful features.
It works with 7.4V, 11.1V and 14.8V batteries. It comes almost completely pre-wired, with only a few simple solder joints required to install the MOSFET.

Features:
Electronic burst
Active brake with adjustable braking power
Precocking (with spring release function)
Rate of fire reduction (for realism or save shots)
DMR mode
Low battery voltage alarm
Programming supported with a multicolored LED diode
Diagnostic system
Electronic resettable fuse

Features description:
Electronic burst:
Change the car into an electronically controlled burst to save ammo and increase realism!
Active brake:
The active brake stops the engine after each shot, preventing spring compression or, in the case of replicas with a high rate of fire, overspin (double shot problem).
Precocking:
The quick trigger response can be a matter of winning or losing, especially in CQB situations. With precocking enabled, the piston will remain in the rear position after each shot with the spring already compressed, ensuring that the next shot is fired immediately after the trigger is pulled. To release the spring after using precocking, press the trigger while holding the button on the unit. One shot will be fired, without precocking and fully braked.
Fire rate reduction:
Reduce the rate of fire in auto or burst mode to save ammo or make the replica fire more realistically.
DMR mode:
It introduces intervals between semi-automatic shots to comply with the DMR rules on some fields.
Low battery voltage alarm:
Dedicated for Li-Po and Li-Ion batteries. If the battery voltage drops to a dangerously low level, the user will be alerted by short beeps that repeat every minute. This can also be turned on and off freely.
Diagnostic system:
Constantly monitor the replica and the mosfet itself. If there is any problem, it immediately lets you know what it might be, making troubleshooting a lot easier.
Electronic fuse:
will save the replica and battery in case of a major malfunction. It will automatically disconnect the battery if a short circuit or blocked motor is detected.

All settings are programmed exclusively via trigger and button on the device, in quick and easily memorable sequences. Programming is supported by sound signals and multicolored LED diode. This allows settings to be changed at any time, in seconds, even under enemy fire.
The upgrade kit works seamlessly with any 7V to 17V battery. It can also be used with the most extreme configurations, without any limitation regarding the value of the spring.